<div dir="ltr">I am upgrading an embedded linux board's BSP from 1.0.0m to 1.0.1l due to a requirement for TLS v1.1. Version 1.0.1 will cross compile without errors using my 1.0.0 configuration but I have identified the following errors on the board (so far) with the build using 1.0.1:<div>1.) Cannot create a RSA key</div><div>2.) Trying to connect to the board's Lighttpd web server via https will timeout with PKCS #11 error</div><div>3.) Curl https POST calls fail with RSA padding error.</div><div><br></div><div>Board has a ARM926EJ based processor and I am using a Codesourcery Lite toolchain. Configure settings (besides --prefix, etc) are shared, no-asm, linux-generic32, no-ssl2. All the other packages on the board have been rebuilt against the new openssl version.</div><div><br></div><div>I am looking at the key creation first since that may be causing the other issues. If I try to create a key from the board command line using "openssl genrsa -out testkey.pem 2048" I get a response of "Generating RSA private key, 2048 bit long modulus". At this point it seems to get stuck in a loop; I am seeing the progress indicators (".") but it will never finish creating the key. I have let it run 10-15 minutes without completion; it just keeps displaying successive progress indicators. I can do Ctrl-C and it will exit. </div><div><br></div><div>I don't think so but are there any dependency changes from 1.0.0 to 1.0.1?</div><div><br></div><div>I noticed 1.0.2 has been released so tried that as well but have the same result as 1.0.1</div><div><br></div><div>Mike</div><div><br></div><div><br></div></div>